Set buffer time in Microsoft Bookings
Some of your appointments might require time before or after you meet with your customer to set up, clean up, or reset your room and equipment. Or if you’re on the road between customer appointments, you may need time to ensure you and your team can travel between appointments without making the customer wait.
You can set buffer time before appointments start, after appointments end, or both to give staff the extra time they need to prepare for their next appointment.
Set buffer time defaults
Buffer time defaults are set on the Service details page in Bookings. Like all service defaults set on this page, these defaults can be edited by you for a specific booking to meet specific customer needs.
The buffer time setting can be found on the Service details page. Before it can be set for a given service, you must enable the buffer time setting by selecting the buffer time toggle. This causes the Before and After drop-downs to appear, which are used to pick the default amount of time to hold before and after each booking, as shown here:
Buffer time and availability
Your customers don’t directly see and cannot change the buffer times you set. However, because buffer time is used to calculate overall service duration, customers will see you and your relevant staff as booked during both buffer and regular appointment times. Customers also only see availability for you and your staff if there is enough time for both the appointment and its buffer time.
As an example, a one-hour appointment with a 15-minute pre-appointment buffer time requires an available time block of at least 1 hour and 15 minutes. An appointment for this service would therefore fill a 75-minute block of time on your calendar and needs 75 minutes of availability to book without conflict.