Freigeben über

Configuring a Firewall on a File Server

  • Artikel

Published : September 27, 2005

To configure a firewall on a file server, you must open port 135 to TCP traffic, and you must enable the file agent (Msdpmfsagentca.exe) to communicate through the firewall.

Before you can install, uninstall, or upgrade a file agent on a file server that has a firewall enabled, you must first disable the firewall. After that, you can install, uninstall, or upgrade a file agent by using DPM Administrator Console, and then re-enable the firewall.

The following procedures apply to the Windows Firewall configuration. For instructions on configuring other firewall software, consult the firewall documentation.

To disable Windows Firewall on a file server

  1. In Control Panel, click Windows Firewall.

  2. On the General tab, click Off, and then click OK.

To re-enable and configure Windows Firewall on a file server

  1. In Control Panel, click Windows Firewall.

  2. On the General tab, click On, and verify that the Don’t allow exceptions check box is clear.

  3. On the Exceptions tab, do the following:

    • Click Add Program, click Browse, and navigate to Program Files/Microsoft Data Protection Manager/DPM/bin. Select Msdpmfsagentca.exe, click Open, and then click OK.

    • Click Add Port, type a name for the port in the Name box (you can use any name), type 135 in the Port number box, verify that TCP is specified as the protocol, click OK to close the Add a Port dialog box, and then click OK to close the Windows Firewall dialog box.