IRP_MJ_INTERNAL_DEVICE_CONTROL
In general, any replacement for an existing driver that supports internal device control requests should handle this request in a DispatchInternalDeviceControl routine. Such a driver must support at least the same set of internal I/O control codes as the driver it replaces. Otherwise, existing higher-level drivers might not work with the new driver.
Drivers that replace certain lower-level system drivers are required to handle this request. For example, a replacement for the system parallel port driver must continue to support existing parallel class drivers. Note that certain system drivers that handle this request cannot be replaced, in particular, the system-supplied SCSI and video port drivers.
When Sent
Any time after the successful completion of a create request.
Input Parameters
The I/O control code is contained at Parameters.DeviceIoControl.IoControlCode in the I/O stack location of the IRP.
Other input parameters depend on the I/O control code's value. For more information, see Buffer Descriptions for I/O Control Codes.
Output Parameters
Output parameters depend on the I/O control code's value. For more information, see Buffer Descriptions for I/O Control Codes.
Operation
Drivers receive IRP_MJ_INTERNAL_DEVICE_CONTROL requests when another driver calls either IoBuildDeviceIoControlRequest or IoAllocateIrp to create a request.
This I/O control code has been defined for communication between paired and layered kernel-mode drivers, such as one or more class drivers layered over a port driver. The higher-level driver sets up IRPs with device- or driver-specific I/O control codes, requesting support from the next-lower driver.
The requested operation is device- or driver-specific.
For general information about I/O control codes for IRP_MJ_DEVICE_CONTROL or IRP_MJ_INTERNAL_DEVICE_CONTROL requests, see Using I/O Control Codes. See also Device Type-Specific I/O Requests.
Requirements
Header |
Wdm.h (include Wdm.h, Ntddk.h, or Ntifs.h) |