Cannot configure all virtual directories via /ecp

Question

Hi All,

I have Installed another one Exchange 2016 server into to the system after that I found that I could not configure all virtual directories via ECP, although I have accessed the ECP via directly login the server. please see the picture below,

Please help me or suggest the solutions to resolve the issue.

Thank you in advance,

Tanisorn

Answer 1

Hi @Tanisorn Sowudomsilp ,

 

In response to your question, I have the following suggestions:

 

1. Please check that there are no restrictions in the firewall to make sure port 443/80 is enabled, refer to related similar thread: The Version of Internet information services (IIS) that is running
2. Please make sure the Remote Registry service is running, as follows:
   
3. If the issue persists, please have a look at the Event Viewer and see if there’s any potentially relevant events recorded out there.

---

If the answer is helpful, please click "Accept Answer" and kindly upvote it. If you have extra questions about this answer, please click "Comment". 

Note: Please follow the steps in our documentation to enable e-mail notifications if you want to receive the related email notification for this thread.

Answer 2

Hi @Tanisorn Sowudomsilp ,

It seems a network issue.

Check if all required port are opened :

Network ports for clients and mail flow in Exchange

Similar thread : Unable to edit CAS Server settings from ECP

Please don't forget to mark helpful answer as accepted