Azure NAT Gateway
NAT Gateway is a fully managed service that securely routes internet traffic from a private virtual network with enterprise-grade performance and low latency.
38 questions
why wont it show my subnets during natgw config?
Allwyn Mascarenhas
0
Reputation points
HI
The subnets in my vnet dont have any of these restrictions still i cant see them during the natgw config, what am i missing?
{count} votes
-
TP 98,176 Reputation points2023-09-17T23:52:33.77+00:00 As a test, please create NAT gateway with subnet set to None. Once it is created, navigate to the NAT Gateway, click on Subnet and see if it shows/allows you to select your Subnet1. If it doesn't work you can go ahead and delete the NAT gateway so you aren't being charged while it is not functioning.
-
Allwyn Mascarenhas 0 Reputation points
2023-09-18T01:33:55.97+00:00 Hi . .the think is i already deleted the natgw to avoid charges, but not sure what was wrong.
This is just for educational purposes but really want to figure out what was wrong..
-
TP 98,176 Reputation points
2023-09-18T01:41:09.33+00:00 Okay, I thought you stopped and didn't create it because it wouldn't allow you to select your subnet. I was wondering if you went ahead and created it with None for subnet, and then after it is created attempted to select it would it work. Shouldn't make a difference but since it only takes a minute I thought it was worth a try.
On my end I have tried different ways to get it to not show my subnets and it always shows them. Have several different VNets and switched between them and the subnets would show up every time.
Sign in to comment
Sign in to answer