Error Code 0x8007000D

Hi RT. I'm Greg, an installation specialist, 10 years awarded Windows MVP, and Volunteer Moderator, here to help you.

How did you load the WIndows 10 ISO into the flash stick? It needs to be written by the Media Creation Tool following the instructions in the middle of the downloads page here: https://www.microsoft.com/en-US/software-downlo.... This will destroy all data on it so it needs to be backed up first.

I will give you all possible steps to troubleshoot Windows installation failure which work in about 90% of cases. If not we'll go from there:

Follow the illustrated Clean Install steps in this tutorial which compiles the best possible install that will stay that way as long as you stick with the tools and methods given: http://answers.microsoft.com/en-us/windows/wiki...

Make sure all other drives and peripherals are unplugged. Update the BIOS or UEFI firmware to latest, or reset to Defaults, making sure UEFI is enabled, CSM or Legacy BIOS disabled, Windows Boot Manager set first to boot, if necessary disable Secure and Fast Boot until after install. Access BIOS/UEFI Setup as shown here: https://www.mydigitallife.net/comprehensive-lis...

https://www.groovypost.com/howto/reset-pc-bios-...

Create the latest Windows 10 Installation Media by installing Media Creation Tool and following the directions here: http://windows.microsoft.com/en-us/windows-10/m.... If you're using another PC to do this uncheck the box for Recommended Settings to choose the exact version and bit rate for the target PC only.

Insert media, boot it by powering up PC while pressing the BIOS Boot Menu Key: https://www.sysnative.com/forums/hardware-tutor...

If the media won't boot you may need to enter BIOS/UEFI Setup (pressing key given in chart in link above) to turn off Fast Boot or Fast Startup first. If you can start Windows enter UEFI firmware here: http://www.isunshare.com/windows-password/four-...

Choose the boot device as a UEFI device if offered, on first screen press Shift + F10 to open a Command Prompt, type the following commands, each followed by Enter key:

DISKPART

LIST DISK

SEL DIS # (replace # with the disk # of the Windows disk from list in previous command)

CLEAN

EXIT

Close Command Box, on second screen choose Install Now, then Custom Install, then at the drive selection screen choose Unallocated Space, click Next to let it create needed partitions and start install - this makes it foolproof.

Make sure to follow the setup steps in the first link tutorial to complete your install. Drivers are important enough that those steps are printed in red.

You will get and keep the best possible install to the exact extent you stick with the steps, tools and methods in the first linked tutorial. It's a better install than any amount of money could buy and a great learning experience that will make you the master of your PC.

If all else fails you can move the hard drive to another PC to do the install with it plugged in alone. Windows 10 is remarkably adaptive to new hardware without needing adaptive restore. If it will start it will swap out all drivers requiring several restarts. You can also try applying a same-version System Image to the intact SSD/hard drive.

I hope this helps. Feel free to ask back any questions and let us know how it goes. I will keep working with you until it's resolved.

________________________________________________________

Standard Disclaimer: There are links to non-Microsoft websites. The pages appear to be providing accurate, safe information. Watch out for ads on the sites that may advertise products frequently classified as a PUP (Potentially Unwanted Products). Thoroughly research any product advertised on the sites before you decide to download and install it.