SATA AHCI doesnot start

Question

The hypervisor could not perform the operation because the object or value was either already in use or being used for a purpose that would not permit completing the operation.

Answer 1

i have the same problem on Windows 11 build 25247

Answer 2

Hi. Thank you for your question and reaching out.

You're experiencing this issue maybe because it is not yet enabled. Please follow these:
Turn off your computer.
When the computer is turned on, press the F2 key to enter the BIOS.
Visit the System or Hardware configuration page (this will differ based on BIOS).
Seek out the AHCI or SATA mode.
Enable AHCI or set AHCI under SATA mode.
BIOS save and exit.
We'll enable AHCI.

-----------------------------------------------------------------------------------------------------------------

If the reply was helpful, please don’t forget to upvote or accept as answer, thank you.

Answer 3

I have same issue with Windows 11 build 25247