DL380 gen 7 os install error.

Question

DL380 gen 7 os install error.

I am using 4 hdds, and each raid 0 is being configured. When raid is not configured, the hard disk is not displayed during os installation, so all of them are configured as raid 0.

The problem is, the raid configuration was configured with raid 0 of each hard, and the error details are as follows, This computer's hardware may not support booting to this disk.

Ensure that the disk's controller is enabled in the computer's bios menu.

The server I'm using has either a SATA setting or an AHCI setting.

It also shows the contents with the setting path that others told me about.

Is it a problem with SATA setting or AHCI setting?

Or, if you have any other solutions to try, please help.

Answer 1

Hi @help ,

The installation should work more or less on any RAID configuration, have you got the latest drivers & firmware installed?

Which Windows Server operating system are you attempting to install? Make sure your HPE hardware supports it:
https://www.windowsservercatalog.com/

Also something here might help:
https://community.hpe.com/t5/proliant-servers-ml-dl-sl/hp-proliant-380-g7-server-not-detecting-the-hard-drives/td-p/6206191#.X7yz3s1KiUk

----------

(If the reply was helpful please don't forget to upvote or accept as answer, thank you)

Best regards,
Leon

Answer 2

You have configured an appropriate raid and installed a supported operating system.

I did not select a disk to boot from and tried continuously, so I could not proceed at the OS installation stage.

When I selected the boot disk, the installation proceeded normally.

Thank you for your response.

Answer 3

Same Error here at first.
In the Raid Controller configuration, I had to select the Partition to boot from...
after this, it worked like a charm...