Opening instructions of Lab for this unit has student to clone the repository for the course in Command Prompt, but it does not seem to work. We are prompted for a username / password but the instructions make no mention about that.

Hi Alain Bousquet , Thank you for reaching out to us on Microsoft Q&A forum. We tried from our end; it's working fine for us. Kindly refer the below screenshots. Please follow the lab instructions, whatever mentioned in the right side when you launched the Lab. If you are still facing any issue, please let us know in the comments. We are glad to help you. If the information is helpful, please Accept Answer so that it would be helpful to community members. Thank you.

Power BI Data Analyst Learning Path: Work with Power BI model relationships

Accepted answer

Syed Saleem Peera 1,955 Reputation points Microsoft Vendor

2024-07-12T05:38:53.2733333+00:00

Hi Alain Bousquet,

Thank you for reaching out to us on Microsoft Q&A forum.

We tried from our end; it's working fine for us. Kindly refer the below screenshots. Please follow the lab instructions, whatever mentioned in the right side when you launched the Lab.

If you are still facing any issue, please let us know in the comments. We are glad to help you.

If the information is helpful, please Accept Answer so that it would be helpful to community members.

Thank you.
Please sign in to rate this answer.
Syed Saleem Peera 1,955 Reputation points Microsoft Vendor

2024-07-13T04:08:31.8633333+00:00

Hi Alain Bousquet,

Just checking in to see if you had a chance to see the previous answer. Please let me know if it was helpful and don't hesitate to reach out to us if you face any issue.

If the information is helpful, please Accept Answer so that it would be helpful to community members.

Thank you.

Alain Bousquet 40 Reputation points

2024-07-13T22:44:23.5833333+00:00

Hi Syed,

Thanks again for the response; the section you referred to is indeed where I experienced problems. It turns out I could not - no matter how careful I was - type in the command properly, and found out - thanks to a tip somewhere in the discussion forum - that it is better to copy and paste those commands when possible; which is what I ended up doing and it worked!

Keep up the good work.

Best regards,

Alain
Sign in to comment

Share via

Power BI Data Analyst Learning Path: Work with Power BI model relationships

0 additional answers