Share via

Reset Network Adapters using CMD

Reported
Anonymous
2018-02-06T11:01:08+00:00

Split from this thread.

how do you reset network adaptors using command promt

Windows for home | Other | Internet and connectivity

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments

1 answer

Sort by: Most helpful
Most helpful Newest Oldest
  1. franco d'esaro 24,891 Reputation points Volunteer Moderator
    2018-02-06T13:05:45+00:00

    Hi KHUMO N MAKUKUMAKUKU,

    Open PowerShell or Command Prompt and run as administrator, type the following commands by pressing enter at the end of each command line:

    netsh winsock reset

         netsh int ip reset

         netsh advfirewall reset

       ipconfig / flushdns

        ipconfig / release

        ipconfig / renew

      Close and restart the computer at the end of all the commands.

    0 comments