Share via

I keep having kernel power bsod errors, can someone read my dump file to find the issue?

Anonymous
2024-10-01T13:11:22+00:00

dump file

Windows for home | Windows 11 | Performance and system failures

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments

17 answers

Sort by: Most helpful
Most helpful Newest Oldest
  1. DaveM121 891.6K Reputation points Independent Advisor
    2024-10-01T14:59:38+00:00

    Okay, in that case, please disable Verifier and wait for your system to crash normally again and then please upload any new minidump files you may get for analysis.

    Was this answer helpful?

    0 comments
  2. Anonymous
    2024-10-01T14:44:15+00:00

    Thank you for your info, i was running driver verifier for some days but even though the pc was running slow, no crashes occurred, the moment i disabled it the bsod started again

    Was this answer helpful?

    0 comments
  3. DaveM121 891.6K Reputation points Independent Advisor
    2024-10-01T14:22:25+00:00

    Your minidump files just indicate memory (RAM) corruption no specific driver is listed

    1

    The best option is to download the widely available free utility MemTest86, then run a full 4 pass scan with that to test your RAM for physical errors

    2

    If no RAM errors are found, to try to force Windows to show any faulting drivers, the best option would be to turn on Driver Verifier, let your PC crash 3 times, then you must turn off Driver Verifier, and finally, upload any newly created minidump files

    Before you run Driver Verifier, please create a new System Restore Point

    https://answers.microsoft.com/en-us/windows/for...

    Note, if you have any difficulty getting into Windows with Driver Verifier enabled:

    Start your PC, just as Windows attempts to load (spinning dots), press and hold Power Button for 5 - 10 seconds to perform a Hard Shut Down

    Do this twice

    On the third start Windows will boot into the Recovery Environment and from there you can access System Repair, Safe Mode, Command Prompt... etc.

    Go to Troubleshoot - Advanced Option - Startup Settings and click Restart

    Upon restart, press 4 to enter Safe Mode

    Open Command Prompt as Administrator and run these two commands, then restart your PC.

    verifier /reset

    verifier /bootmode resetonbootfail

    Was this answer helpful?

    0 comments
  4. Anonymous
    2024-10-01T14:18:57+00:00

    yes it is an ongoing issue, this single minidump is from today with a fresh format, the ones im linking below are from pre format some days ago

    dumpfiles

    Was this answer helpful?

    0 comments
  5. DaveM121 891.6K Reputation points Independent Advisor
    2024-10-01T13:43:52+00:00

    Hi, I am Dave, I will help you with this.

    Your one minidump file just listed generic RAM corruption as the cause of that crash, nothing specific.

    If this is an on-going problem, do you have any more minidump files available that you can upload for analysis?

    Was this answer helpful?

    0 comments