Share via

Frequent Hypervisor Error and Driver irql not less or equal

Anonymous
2023-10-03T12:34:22+00:00

I am using Windows 11 Home.

The processor is AMD Ryzen 5 3600.

Virtualization is enabled in BIOS.

Virtual Machine Platform and Windows Hypervisor Platform are enabled in optional features.

Display adapter is updated and up to date using GeForce experience.

Windows updates are also up to date.

Here's the link for the Memory.DMP and minidumps.
dumps

Thank you.

Windows for home | Windows 11 | Performance and system failures

Locked Question. This question was migrated from the Microsoft Support Community. You can vote on whether it's helpful, but you can't add comments or replies or follow the question.

0 comments No comments

1 answer

Sort by: Most helpful
  1. DaveM121 891.6K Reputation points Independent Advisor
    2023-10-03T14:09:31+00:00

    Hi, I am Dave, I will help you with this.

    Your minidump files just indicate memory (RAM) corruption no specific driver is listed

    1

    The best option is to download the widely available free utility MemTest86, then run a full 4 pass scan with that to test your RAM for physical errors

    2

    If no RAM errors are found, to try to force Windows 11 show any faulting drivers, the best option would be to turn on Driver Verifier, let your PC crash 3 times, then you must turn off Driver Verifier, and finally, upload any newly created minidump files

    Before you run Driver Verifier, please create a new System Restore Point

    https://answers.microsoft.com/en-us/windows/for...


    Note, if you have any difficulty getting into Windows with Driver Verifier enabled:

    Start your PC, just as Windows attempts to load (spinning dots), press and hold Power Button for 5 - 10 seconds to perform a Hard Shut Down

    Do this twice

    On the third start Windows will boot into the Recovery Environment and from there you can access System Repair, Safe Mode, Command Prompt... etc.

    Go to Troubleshoot - Advanced Option - Startup Settings and click Restart

    Upon restart, press 4 to enter Safe Mode

    Open Command Prompt as Administrator and run these two commands, then restart your PC.

    verifier /reset

    verifier /bootmode resetonbootfail

    Was this answer helpful?

    0 comments No comments