How to fix kernel power event 41

Miles Tomlin 10 Reputation points
2026-04-02T06:59:04.1266667+00:00

I've had this problem for about two months now and it's incredibly odd. Whenever I launch or try to play certain games my computer black screens, my DRAM light turns red on my motherboard, and it restarts within 15 seconds. I've updated my bios to the latest update, done a clean install on my computer, made sure all of my drivers were updated and no fix, checked loose cables, made sure my temperatures were fine, ran a memory diagnostic on both sticks of ram in both slots and no problems were found and I cannot seem to find a permanent solution. The only thing I noticed that kind of worked was I only put one of my ram sticks in and it seemed to work for about a week. I say this because before I tried this I tried to launch Rainbow six siege, and madden 26, my pc would immediately restart, and after I put only the one stick in I was able to play all of my games just fine. Now the problem has started again and I can't play even the simplest games to run like Fortnite or even risk of rain 2 which was not the case before hand. When I go into event viewer it says "critical error event ID 41 task category 63" I really have no clue what's going on and I really would like to find some sort of information as to what is causing this issue so I don't have to just blindly buy a new component and that not work as well.

PC Specs:

Motherboard: B650 Aorus Elite AX

CPU: AMD Ryzen 5 7600x 6 core, 4701 MHZ

Gpu: AMD Radeon RX 7700xt

Memory: 32 GBs DDR5 ram

PSU: 850 W

Windows for home | Windows 11 | Performance and system failures
0 comments No comments

3 answers

Sort by: Most helpful
  1. AI answer

    2026-04-02T06:59:22.6+00:00

    Event ID 41 (Kernel-Power) only tells that Windows detected an unexpected/dirty shutdown. In this scenario, the DRAM LED on the motherboard and the fact that the issue changes when RAM configuration changes strongly point to a hardware problem, most likely memory, memory configuration, or power/board-related.

    Use Event ID 41 only as a symptom and focus on hardware isolation as in Scenario 3 from the documentation:

    1. Treat this as a hardware stability issue (Scenario 3)
      • Event ID 41 with gaming load, black screen, and DRAM LED, and no clear bugcheck code typically indicates a hardware problem rather than a Windows/software issue.
      • According to Scenario 3, when Event ID 41 appears without useful bugcheck data, the common causes are power, memory, overheating, or platform/firmware issues.
    2. Disable any overclocking or aggressive profiles
      • In BIOS/UEFI, reset everything to defaults (no CPU overclock, no RAM overclock/XMP/EXPO, no GPU overclock).
      • Ensure the system is running at JEDEC/default RAM speed and voltage.
      • The documentation explicitly recommends disabling overclocking and verifying if the problem reproduces at correct speeds.
    3. Systematic memory checks
      • Because the DRAM LED lights and the system behavior changed when using a single stick, memory is a prime suspect.
      • Follow the guidance to “check the memory”:
        • Test each RAM stick individually in the same slot under gaming load.
        • Then test the same stick in each memory slot to see if a particular slot is faulty.
        • Use a memory checker (for example, bootable memory test) to stress the RAM.
      • Verify all memory modules are running at the same speed and correctly configured.
    4. Check the power supply and power path
      • Scenario 3 highlights that an underpowered or faulty PSU can cause random restarts without a proper bugcheck.
      • Even with an 850 W PSU, there could be:
        • A defective unit
        • Bad PCIe power cable or loose connection
      • Reseat all power connectors (24‑pin ATX, 8‑pin CPU, GPU PCIe cables) and, if possible, test with a known-good PSU.
    5. Check for overheating and platform stability
      • Scenario 3 also recommends checking for overheating:
        • Confirm CPU and GPU temperatures under load are within safe limits.
        • Ensure all fans are working and the case has adequate airflow.
      • Since the DRAM LED is involved, also inspect the motherboard physically for any visible damage around the DIMM slots (burn marks, bent pins, debris).
    6. If running in a virtualized or clustered environment (not your case)
      • The documentation notes heartbeat-based restarts in Hyper‑V/VMware or clusters, but with a physical gaming PC this is not relevant; focus on physical hardware.
    7. Use the event log only to correlate times
      • Event ID 41 confirms the time of the improper shutdown.
      • Also check for:
        • Event ID 6008 (unexpected shutdown)
        • Event ID 46 from volmgr (Crash dump initialization failed!) which would indicate dump configuration issues, not the root cause.

    If, after disabling overclocks, thoroughly testing RAM (sticks and slots), verifying PSU and power connections, and confirming temperatures, the issue persists, the remaining likely culprits are the motherboard (memory controller/slots or power delivery) or the PSU. At that point, replacing or testing with known-good RAM and PSU, then the motherboard, is the standard next step to avoid “blind” replacement.


    References:

    AI-generated content may be incorrect. Read our transparency notes for more information.

    Was this answer helpful?

    2 people found this answer helpful.
  2. Biswarnj Patra 0 Reputation points
    2026-06-10T23:21:32.78+00:00

    i hv same reboot issu but i dont hv any file on C:\Windows\Minidump its empty, how to knw why its happening ???

    Was this answer helpful?

    0 comments No comments

  3. DaveM121 919.8K Reputation points Independent Advisor
    2026-04-02T07:33:12.5366667+00:00

    Kernel 41 (63) errors usually do indicate a hardware problem, not software.

    Please check to see if your PC is producing any minidump files, I will check those to see if they provide any insight into a potential cause of the system crashes.

    Please do not upload a very large Memory.dmp file.

    Open Windows File Explorer.

    Navigate to C:\Windows\Minidump

    Copy any minidump files onto your Desktop, then zip those up.

    Upload the zip file to the Cloud (OneDrive... etc.), then choose to share those and get a share link.

    Then post the link here to the zip file, so I can take a look for you.

    Was this answer helpful?


Your answer

Answers can be marked as 'Accepted' by the question author and 'Recommended' by moderators, which helps users know the answer solved the author's problem.