Share via


Issues with Installation of SharePoint 2010 SP1

I recently had a situation where we were installing SharePoint 2010 SP1 update in our SharePoint Farm.  The installation began fine and we were able to install on the first server with no issues.  When we began the update on the second and third servers in the farm when all seemed well.  However executing a few PowerShell commands yielded a message telling us that SharePoint Service Pack 1 was missing.  We tried to re-install the update to no avail, in fact getting a message that the update was already installed.  After filtering through some emails I notice that there have been others in this position and the recommended  solution worked for us.  This solution was to run “Get-SPProduct –local” on the server.  This PowerShell command kicks off the Product Version Timer Job which will update the information causing the initial problem and in effect let’s SharePoint know the current version.

HTH

Comments

  • Anonymous
    July 05, 2011
    Hi All, I have published an article describing the steps required to install and configure SharePoint Server 2010 SP1 on the existing farm with screen shots.  See below URL for detail. www.sp-blogs.com/.../Post.aspx Thanks Adnan Ahmed Owner: www.sp-blogs.com

  • Anonymous
    August 05, 2011
    Hi Karimka, very good catch. I had same issue. Installed everything and when I ran config wizard it complained just about 1 (of 4) servers that was missing a SP1, lang packs and so on. Your command did the trick. After running it, I started config wizard again and now I´m praying for the rest to go well. Thanks a lot!