STSN

Set and test sequence numbers (STSN) are used on sessions with Transmission Service profile (TS profile) 4 for applications to maintain transaction processing sequence numbers between sessions. This enables both partners on the session to discover the amount of data lost after a CLEAR or UNBIND–BIND sequence.

The STSN message is the only one that can reset such transaction processing sequence numbers. BIND, UNBIND, and CLEAR do not affect them.

If the application wants to maintain such transaction numbers, it must specify the APPLTRAN option in the Open(PLU) OK Response. The host can send STSN after a BIND or CLEAR before sending SDT to set or test the application's transaction numbers. The local node resets its internal session sequence numbers to zero on receipt of BIND or CLEAR. When the local node receives an STSN specifying SET (or SET and TEST) for one half-session, it resets the corresponding internal session sequence number.

Unless both half-session actions are ignore (the action byte is 0x00), the STSN request is passed to the application (provided that it specified APPLTRAN), with the action byte and the two sequence numbers from the request, as a Status-Control(STSN). (For more information, see Status-Resource.) The application must examine the action byte to determine whether the action is ignore, set, test, or set and test. The application must send a positive response (Status-Control(STSN) Acknowledge) to the STSN, with the sensed sequence numbers if required (sense or set and test). The local node is responsible for generating the correct result code for the STSN RSP.

Note that the application should perform the sense part of STSN first (by examining bits 0 and 2 of the action byte for the secondary-to-primary flow and primary-to-secondary flow respectively). The set part of the STSN is then performed (by examining bits 1 and 3 of the action byte).

The application should increment its transaction numbers when sending and receiving normal flow request/response units (RUs) from the host. (Note that Status-Control messages corresponding to normal flow data flow control (DFC) requests cause the transaction numbers to be incremented.) The sequence number is reported on DATAFMI messages and Status-Acknowledge messages. The application should be aware that, if a message from the host fails receive checks (and is converted to an SDI message), sub-network access protocol (SNAP)-2.1 will purge the remainder of the chain from the host, and the application may miss some sequence numbers. Therefore, the application should reset its primary-to-secondary transaction number from the next outbound data after processing an SDI message.

Note that the second application flag byte is not valid for Status-Control(STSN). It is used for the STSN control byte.

See Also

Application CANCEL
Direction after Receiving a Negative Response
Direction after Sending a Negative Response
Critical Failure
RQR and CLEAR
Link Service Failure
Local Node Failure
Client Failure