Text that is in a text box control of a report or a form may not appear correctly in Access
Original KB number: 839779
This article applies to either a Microsoft Access database (.mdb) file or to a Microsoft Access database (.accdb) file, and to a Microsoft Access project (.adp) file. Novice: Requires knowledge of the user interface on single-user computers.
Symptoms
In Microsoft Access, you can set the Vertical property of a text box control to Yes in a report or in a form. When you do this, you may notice that the text that is in the text box control does not appear correctly. You may notice any one of the following problems:
- The font of the text that is in the text box control changes to a different font.
- The text box control appears blank.
- The text that is in the text box control changes to text that is not readable.
Workaround
Important
This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
322756 How to back up and restore the registry in Windows
To work around this problem, add the following registry entry, and then set the DWORD value to 1.
HKEY_CURRENT_USER\Software\Microsoft\CTF\Disable Thread Input Manager
To do this, follow these steps:
Click Start, click Run, type regedit, and then press ENTER.
Locate the following registry subkey:
HKEY_CURRENT_USER\Software\Microsoft\CTF
Right-click CTF, point to New, and then click DWORD Value to create the following entry:
Disable Thread Input Manager
Note
If you are running an x64-based version of Windows, click DWORD (32-bit) Value to create the entry.
Double-click Disable Thread Input Manager, type 1, and then click OK.
Exit Registry Editor, and then restart the computer.