Share via

3.1.4.1.49 ApiGetNodeId (Opnum 48)

  • Article

(Protocol Version 2) The ApiGetNodeId method returns the unique ID of the designated node.

The server SHOULD accept an ApiGetNodeId request if its protocol server state is read-only and MUST accept the request for processing if it is in the read/write state, as specified in section 3.1.1. 

 error_status_t ApiGetNodeId(
   [in] HNODE_RPC hNode,
   [out, string] LPWSTR *pGuid
 );

hNode: An HNODE_RPC context handle that was obtained in a previous ApiOpenNode method call.

pGuid: The address of a pointer that receives a pointer to a Unicode string buffer where the server MUST return the unique ID of the node after successful completion of this method. The server MUST allocate as much memory as is required to return the ID. If the method fails, this parameter MUST be ignored.

Return Values: The method MUST return the following error codes for the specified conditions.

Return value/code

Description

0x00000000

ERROR_SUCCESS

Success.

0x00000006

ERROR_INVALID_HANDLE

The hNode parameter does not represent a valid HNODE_RPC context handle.

0x000013AC

ERROR_NODE_NOT_AVAILABLE

The node represented by the hNode parameter no longer exists in the non-volatile cluster state.

For any other condition, this method MUST return a value that is not one of the values listed in the preceding table. The client MUST behave in one consistent, identical manner for all values that are not listed in the preceding table. The client SHOULD treat errors specified in 3.2.4.6 as recoverable errors and initiate the reconnect procedure as specified in section 3.2.4.6.