WAP Physical Proxy: PXPHYSICAL

The following table lists the parms in PXPHYSICAL element processed by the device.

WAP characteristic	WAP parm	Supported	Comments
PXPHYSICAL		Yes	For an acceptable proxy, a globally unique identifier (GUID) will be created. It is set as DestID in the Connection Manager proxy definition. A network entry of CM_Networks will also be defined. The network name uses the following format: NAME + "@" + PHYSICAL-PROXY-ID + "@" + "PROXY-ID" + "@PXLOGICAL" NAME is the NAME parm in the PXLOGICAL element.
	PHYSICAL-PROXY-ID	Yes	For each WAP proxy in Connection Manager, the WAP proxy name is the combination of PHYSICAL-PROXY-ID and its corresponding logical proxies PROXY-ID and TO-NAPID. PHYSICAL-PROXY-ID + " @" + PROXY-ID + " @" + TO-NAPID
	DOMAIN	Yes	If no DOMAIN parm is supplied, the corresponding parm value from the logical proxy definition is used. The DOMAIN parm and the GUID of this proxy will be set as entries of the Connection Manager mapping table. The value of DOMAIN will be modified to match the mapping table's request for the device.
	PXADDR	Yes
	PXADDRTYPE	Yes	On Smartphone 2002 and Pocket PC 2002 devices, only the IPv4 address type is accepted by Pocket Internet Explorer. E164 addresses will also be saved; however, they will be used by the Push Router only as a push proxy address if the PUSHENABLED parm is set. On Smartphone 2003 and Pocket PC 2003 devices, the IPv6 proxy address type can also be provisioned. The push proxy NAPDEF settings that use the Global System for Mobile Communications (GSM)-Short Message Service (SMS) bearer are ignored. Push Proxy Gateway (PPG) should use the Short Message Service Center (SMSC) that is saved on the Subscriber Identity Module (SIM) card. The SMSC number can be changed by using the Telephony API (TAPI) Configuration Service Provider or by using the GSM network directly.
	PUSHENABLED	Yes
	TO-NAPID	Yes	The PXLOGICAL Configuration Service Provider creates one proxy for only the last TO-NAPID that it finds in a PXPHYSICAL that matches the NAPID of a NAPDEF. The corresponding GUID of the NAPID is set as SrcID in the Connection Manager WAP proxy. Currently, Connection Manager does not support an automatic switch among multiple Point-to-Point Protocol (PPP) settings for one WAP gateway. Only the last TO-NAPID will be accepted.
PXPHYSICAL/ PORT	PORTNBR	Yes
PXPHYSICAL/ PORT	SERVICE	Yes

See Also

WAP Connectivity Parameters Processed by the Device | PXLOGICAL Configuration Service Provider

Send feedback on this topic to the authors.

© 2005 Microsoft Corporation. All rights reserved.