Note
Access to this page requires authorization. You can try signing in or changing directories.
Access to this page requires authorization. You can try changing directories.
Error Messages (MS Comm Control)
The following table lists the trappable errors for the MSComm control.
| Constant | Value | Description |
| comInvalidPropertyValue | 380 | Invalid property value |
| comSetNotSupported | 383 | Property is read-only |
| comGetNotSupported | 394 | Property is read-only |
| comPortOpen | 8000 | Operation not valid while the port is opened |
| 8001 | Timeout value must be greater than zero | |
| comPortInvalid | 8002 | Invalid Port Number |
| 8003 | Property available only at run time | |
| 8004 | Property is read only at runtime | |
| comPortAlreadyOpen | 8005 | Port already open |
| 8006 | The device identifier is invalid or unsupported | |
| 8007 | The device's baud rate is unsupported | |
| 8008 | The specified byte size is invalid | |
| 8009 | The default parameters are in error | |
| 8010 | The hardware is not available (locked by another device) | |
| 8011 | The function cannot allocate the queues | |
| comNoOpen | 8012 | The device is not open |
| 8013 | The device is already open | |
| 8014 | Could not enable comm notification | |
| comSetCommStateFailed | 8015 | Could not set comm state |
| 8016 | Could not set comm event mask | |
| comPortNotOpen | 8018 | Operation valid only when the port is open |
| 8019 | Device busy | |
| comReadError | 8020 | Error reading comm device |
| comDCBError | 8021 | Internal error retrieving device control block for the port |