CEPC-based SDB Motherboard and Card Configuration
Other versions of this page are also available for the following:
8/27/2008
Consult the motherboard documentation for information on configuring the motherboard, the jumper settings for the microprocessor, and system memory. The following table shows a typical hardware configuration for a CEPC that is based on the Asus P5A motherboard. The hardware configuration for your CEPC may be different, depending on the type of motherboard you have chosen and the number of available I/O slots.
Slot number | Card | Interrupt (IRQ) | I/O base | Comments |
---|---|---|---|---|
AGP video slot |
Use a supported AGP-based video card. |
Auto |
None |
Required only if a PCI-based display card is not already used in Slot 1. |
PCI slot 1 |
Use a supported PCI-based video card. |
Auto |
None |
Required. |
PCI slot 2 |
Use a supported PCI-based Ethernet card for downloading and debugging. |
Auto |
0. If you are using a PCI-based network card for downloading and debugging, the driver automatically chooses an appropriate I/O base address that is usable with this card. |
Required only if an ISA-based network card is not already used in ISA slot 2 for downloading and debugging. |
PCI slot 3 |
Use a supported PCI-based Ethernet card for product Ethernet. |
Auto |
Not applicable |
Required only if network data access or networking functionality is needed. |
PCI slot 4 |
Use a supported PCI-based USB controller. |
Auto |
Not applicable |
Required only if USB is not built into the motherboard. |
PCI slot 5 or ISA slot 1 |
Use a supported PC Card Socket adapter. |
11 (ISA) |
0x3E0 — 0x3E1 0x3E2 — 0x3E3 |
Optional. |
ISA slot 2 |
Use a supported ISA-based Ethernet card for downloading and debugging. |
5 |
0x340. If your ISA-based network card does not support this I/O base address, choose a different address that does not conflict with other drivers. |
Required only if a PCI-based network card is not already used in PCI slot 2 for downloading and debugging. |
Built-in COM1: |
Debug serial port. |
4 |
0x3f8 |
None. |
Built-in COM2: |
COM1: |
3 |
0x2f8 |
None. |
Built-in LPT1 |
LPT1 |
7 |
0x278 |
None. |
Built-in USB |
Not applicable |
Auto |
Not applicable |
Optional. |
Built-in audio ![]()
Only if not using the Ensoniq card
|
Not applicable |
Auto |
0x220-0x22F |
None. |
Built-in keyboard and mouse |
Not applicable |
1 |
Not applicable |
None. |
Note
You are not required to use the hardware configuration specified in the table above. However, because Windows Embedded CE is not a Plug and Play OS, if you choose to use a different hardware configuration, you must configure the CEPC correctly and ensure that there are no device conflicts.