Share via


Options for the Windows Embedded CE Stress Tool

Other versions of this page are also available for the following:

Windows Mobile Not SupportedWindows Embedded CE Supported

8/27/2008

In a dialog box for the sServer.exe application on the development workstation, the Windows Embedded CE Stress tool provides options that you can specify to modify the behavior of the tool. You can display additional options by choosing More Options.

The following table shows options for the Windows Embedded CE Stress tool.

Option Description

Hang Detection Trigger

Specifies the duration, in minutes, after which the harness considers some or all of the test modules to stop responding. The default duration is 150 percent of Module Duration.

Hang Detection Action

Specifies the action to take if the harness detects that a test module stops responding.

Reporting Interval

Specifies the time interval, in minutes, at which the harness updates test results and system status.

Module Duration

Specifies the duration, in minutes, for which each test module is requested by the harness to run. The default value is 10 minutes.

If you specify indefinite for module duration, the harness runs the test modules for the duration of the stress run. Specifying indefinite disables hang detection.

Concurrent Modules

Specifies the number of test modules that can run at any given time. The default value is 8.

Verbosity

Specifies a verbosity level for the logs from the test modules. By default, the harness enables abort, failure, warning1, warning2 and comment verbosity levels.

Auto Terminate

Specifies that a termination request be sent to the harness at the specified time.

Auto Launch

Specifies that the harness automatically start running tests at the specified time.

Low Memory Warning Threshold

Specifies when the harness breaks and reports a low memory warning. You can set this value to a percentage of available physical memory consumed or to an absolute amount of physical memory remaining.

Use this option carefully because false positives are common if you set this option. Many test modules have high short-term demands on system resources.

Module Mix

Specifies the set of test modules that run on the target device. If you choose CETK, the Windows Embedded CE Stress tool runs any module that the run-time image supports.

For more information about module mixes, see Creating and Modifying a Module Mix for the Windows Embedded CE Stress Tool.

Test Fail Options

Specifies the conditions under which the Windows Embedded CE Stress tool considers the stress test a failure.

Break on Failure

Specifies that the Windows Embedded CE Stress tool break into the debugger under conditions that you specify for Test Fail Options, if a debugger is attached to the target device.

Log File Location

Specifies the location where the .xml log file is stored.

Test Server Name

Optional. Specifies the network name of another Windows Embedded CE–based device running the Windows Embedded CE Stress tool. The harness passes this network name to the test modules. A test module can use this network name to establish communication with the Windows Embedded CE–based device running the Windows Embedded CE Stress tool.

See Also

Other Resources

Windows Embedded CE Stress Tool