Configuring a Dynamic IP Address on a Run-Time Image

Article
10/07/2008

5/10/2007

By default, all run-time images created in Target Designer are configured to use DHCP. If you set a static IP address on a network interface, you can reconfigure it to DHCP by using Netsh.

To configure a dynamic IP address on a run-time image

Open a command prompt on your run-time image.
Type the following Netsh syntax:
```
netsh interface ip set address "Local Area Connection" dhcp
```
After configuring the dynamic IP address, you can make additional configurations with Netsh, including setting addresses for multiple network interfaces or configuring routers.

Open a command prompt on your run-time image.
Type the following Netsh syntax:
```
netsh interface ip set address "Local Area Connection" dhcp
```
After configuring the dynamic IP address, you can make additional configurations with Netsh, including setting addresses for multiple network interfaces or configuring routers.

See Also

Concepts

How to Configure a Static IP Address on a Run-Time Image

Other Resources

Network Configuration