Share via

OEMInitDebugSerial (Windows Embedded CE 6.0)

  • Article

1/5/2010

This function initializes the debug serial port on the target device.

Syntax

void OEMInitDebugSerial (void);

Parameters

None.

Return Value

None.

Remarks

The kernel calls this function before the OEMInit function and before the kernel data section is fully initialized.

OEMInitDebugSerial can use global variables; however, these variables might not be initialized and might subsequently be cleared when the kernel data section is initialized.

If the device hangs after enabling MMU in KernelStart, it is important to determine whether the problem occurs before OEMInitDebugSerial is called. If it occurs before this API is called, the problem typically is caused by an error in g_oalAddressTable or the cache. First determine whether KernelStart has actually been called by using LED or serial debug output in the startup code. The system can hang if an exception occurs in the kernel initialization code. You can use the same debug output in OEMInitDebugSerial to determine whether the system hangs during MMU initialization. If you can isolate the problem to MMU initialization, the address table or the cache are typically at fault. The LED or serial debug code must handle the different address space that is used before MMU is enabled.

Requirements

Header nkintr.h
Library OEMMain.lib or OEMMain_StaticKITL.lib
Windows Embedded CE Windows CE 2.10 and later

See Also

Tasks

Implementing the Serial Debug Functions

Reference

Boot Loader Debug Functions
OEMClearDebugCommError
OEMInit
OEMReadDebugByte
OEMWriteDebugByte