IPv6 - Static Routes
Applies To: Windows 7, Windows Server 2008 R2
A static routed Internet Protocol version 6 (IPv6) network does not use routing protocols for IPv6 to communicate routing information between routers. Instead, the routing information is stored in a static routing table on each router. You need to ensure that each router has the appropriate routes in its routing table so that traffic can be exchanged between any two endpoints on the IP network.
To create a new static route
In the RRAS MMC snap-in, expand IPv6, right-click Static Routes, and then click New Static Route.
Use the IPv6 Static Route dialog box to configure the route.
To edit the route after you create it, right-click the route, and then click Properties. Use the IPv6 Static Route dialog box to make the changes to the route.
To view the currently defined static routes
In the RRAS MMC snap-in, expand IPv6, and then click Static Routes.
The details pane displays the following information about the currently defined routes:
Destination – the IP address of the network or host to which the route points.
Prefix length– the number of bits in the address that represent the network address. This is typically 64.
Gateway – the IP address of the next hop toward the destination.
Interface – the interface on the local router on which the gateway can be reached and on which the forwarded packet is sent.
Metric – a measure of the cost of using the route. When multiple routes exist that can reach a destination, the route with the lowest metric is selected.