Error Codes (WIA)
Windows Image Acquisition (WIA) functions and methods can return error codes from the following list:
|The device is busy. Close any apps that are using this device or wait for it to finish and then try again.
|One or more of the device’s cover is open.
|Communication with the WIA device failed. Make sure that the device is powered on and connected to the PC. If the problem persists, disconnect and reconnect the device.
|The device is locked. Close any apps that are using this device or wait for it to finish and then try again.
|The device driver threw an exception.
|An unknown error has occurred with the WIA device.
|There is an incorrect setting on the WIA device.
|The device doesn't support this command.
|The response from the driver is invalid.
|The WIA device was deleted. It's no longer available.
|The scanner's lamp is off.
|A scan job was interrupted because an Imprinter/Endorser item reached the maximum valid value for WIA_IPS_PRINTER_ENDORSER_COUNTER, and was reset to 0. This feature is available with Windows 8 and later versions of Windows.
|A scan error occurred because of a multiple page feed condition. This feature is available with Windows 8 and later versions of Windows.
|The device is offline. Make sure the device is powered on and connected to the PC.
|There are no documents in the document feeder.
|Paper is jammed in the scanner's document feeder.
|An unspecified problem occurred with the scanner's document feeder.
|The device is warming up.
|There is a problem with the WIA device. Make sure that the device is turned on, online, and any cables are properly connected.
|No scanner device was found. Make sure the device is online, connected to the PC, and has the correct driver installed on the PC.