Configuring Network Locations to Monitor
上次修改主題的時間： 2009-03-06
You can let the Monitoring Server automatically determine which subnets it will monitor. However, if your network is large or if the subnets are organized hierarchically, you may want to configure the monitoring locations yourself.
The following options are available for determining the network locations that will be monitored:
- Automatic. The Monitoring Server automatically chooses which endpoint subnets to monitor, according to one of the following strategies:
- Endpoint subnets (the default). The Monitoring Server creates subnet locations according to the subnet mask and IP address that are sent from supported call endpoints. This can be a good option for small organizations with a flat organization of subnets.
- Single Subnet Mask. The Monitoring Server creates subnet locations by applying a single administrator-configured subnet mask to the IP addresses that are sent from supported endpoints. When you choose this option, the system’s list of subnets to be monitored will be reset. This is a good option if you want to break up the subnets for monitoring purposes.
The 32-bit binary subnet mask you use must begin with a block of at least two consecutive ones, followed by a block of consecutive zeros.
With either Automatic option, a location appears in the Locations list (which is accessible by clicking the Locations button on the Locations tab) after it has sent quality data to Monitoring Server.
- Imported. You define a list of locations that you want to monitor. You create the list in a comma-separated values (.csv) file, and the file is imported by the Monitoring Server. You can use this list to logically group one or more subnets together, such as all wireless networks for a building or all subnets for a site. For details on how to create a valid .csv file, see Creating a .CSV File to Specify Monitoring Locations.
To specify locations for monitoring
Using an account that is a member of the RTCUniversalServerAdmins group, open the Office Communications Server 2007 R2 snap-in: Click Start, point to Administrative Tools, and then click Office Communications Server 2007 R2.
In the console tree, expand the Forest node, and then expand Monitoring Servers.
Right-click the monitoring server you want to configure, and then click Properties.
In the Properties dialog box, click the Locations tab.
Do one of the following:
To allow the locations to be automatically discovered from endpoint call quality reports, click Automatic. Click the type of automatic location discovery that you want to use. If you click Single subnet mask, type a subnet mask in the corresponding box. After you configure the settings, click OK. Skip the rest of this procedure.
To use a .CSV file to specify locations to monitor, click Imported, and then click Import.
注意
Whenever you change the way that monitoring locations are discovered, Monitoring Server stops monitoring the old locations and starts monitoring the new locations as endpoint call quality reports arrive.
On the Welcome to the Monitoring Server Location Import Wizard page, click Next.
On the Choose Source Location page, enter the location of the .CSV file or click Browse to select a location, and then click Next.
On the Import Confirmation page, click Next.
When the wizard has completed, select the View the log when you click Finish check box, and then click Finish.
In the log file, verify that <Success> appears under the Execution Result column. Look for <Success> Execution Result at the end of each task to verify the locations were imported successfully. Close the log window when you finish.