Poznámka:
Přístup k této stránce vyžaduje autorizaci. Můžete se zkusit přihlásit nebo změnit adresáře.
Přístup k této stránce vyžaduje autorizaci. Můžete zkusit změnit adresáře.
Note
PnPUtil ships with every release of Windows and makes use of the most reliable and secure APIs available. Místo DevCon doporučujeme používat PnPUtil. See Replacing DevCon for more information.
Vytvoří nový kořenový enumeovaný devnode pro zařízení bez plug-and play a nainstaluje jeho podpůrný software. Platné pouze v místním počítači.
devcon [/r] install INFfile HardwareID
Important
PnPUtil ships with every release of Windows and makes use of the most reliable and secure APIs available and its use is recommended. For more information on using PnPutil instead of devcon, see Replacing DevCon.
Parameters
/r
Conditional reboot. Po dokončení operace restartuje systém, když se k provedení změny vyžaduje restartování. Ve výchozím nastavení DevCon nerestartuje systém.
INFfile
Určuje úplnou cestu a název souboru INF pro zařízení. Pokud cestu vynecháte, DevCon předpokládá, že soubor je v aktuálním adresáři.
HardwareID
Určuje ID hardwaru zařízení.
Zadané ID hardwaru musí přesně odpovídat ID hardwaru zařízení. Vzory nejsou platné. Do not type a single quote character (') to indicate a literal value. For more information, see Hardware IDs and Device Identification Strings.
Recommended replacement
devgen /add /bus ROOT /hardwareid HardwareID
pnputil /add-driver INFfile /install
For more recommended replacements, see Replacing DevCon.
Comments
Aby byla tato změna účinná, bude možná potřeba systém restartovat. To have DevCon reboot the system, add the conditional reboot parameter (/r) to the command.
You cannot use the DevCon Install operation for Plug and Play devices.
The DevCon Install operation creates a new non-Plug and Play device node. Then, it uses the DevCon Update operation to install drivers for the newly added device. As a result, the success message for the DevCon Install operation reports that DevCon has created the device node and that it has updated the drivers for the device.
If any step of the DevCon Install operation fails, DevCon displays a failure message and does not proceed with the driver installation.
The DevCon Install command creates a new non-Plug and Play device node each time you run it. To update or reinstall drivers, use the DevCon Update command.
Sample usage
devcon install c:\windows\inf\newdvc.inf ISAPNP\CSC4324\0
devcon /r install c:\windows\inf\newdvc.inf ISAPNP\CSC4324\0