Megjegyzés
Az oldalhoz való hozzáféréshez engedély szükséges. Megpróbálhat bejelentkezni vagy módosítani a címtárat.
Az oldalhoz való hozzáféréshez engedély szükséges. Megpróbálhatja módosítani a címtárat.
Note
PnPUtil ships with every release of Windows and makes use of the most reliable and secure APIs available. A DevCon helyett a PnPUtil használatát javasoljuk. See Replacing DevCon for more information.
Létrehoz egy új, root-enumerált devnode-ot egy nem Plug and Play-eszközhöz, és telepíti annak támogató szoftverét. Csak a helyi számítógépen érvényes.
devcon [/r] install INFfile HardwareID
Important
PnPUtil ships with every release of Windows and makes use of the most reliable and secure APIs available and its use is recommended. For more information on using PnPutil instead of devcon, see Replacing DevCon.
Parameters
/r
Conditional reboot. A művelet befejezése után újraindítja a rendszert, amikor újraindításra van szükség a módosítás hatékonyságának eléréséhez. Alapértelmezés szerint a DevCon nem indítja újra a rendszert.
INFfile
Megadja az eszköz INF-fájljának teljes elérési útját és fájlnevét. Ha kihagyja az elérési utat, a DevCon feltételezi, hogy a fájl az aktuális könyvtárban található.
HardwareID
Megadja az eszköz hardverazonosítóját.
A megadott hardverazonosítónak pontosan meg kell egyeznie az eszköz hardverazonosítójával. A minták érvénytelenek. Do not type a single quote character (') to indicate a literal value. For more information, see Hardware IDs and Device Identification Strings.
Recommended replacement
devgen /add /bus ROOT /hardwareid HardwareID
pnputil /add-driver INFfile /install
For more recommended replacements, see Replacing DevCon.
Comments
Előfordulhat, hogy újra kell indítani a rendszert a módosítás hatékonyabbá tétele érdekében. To have DevCon reboot the system, add the conditional reboot parameter (/r) to the command.
You cannot use the DevCon Install operation for Plug and Play devices.
The DevCon Install operation creates a new non-Plug and Play device node. Then, it uses the DevCon Update operation to install drivers for the newly added device. As a result, the success message for the DevCon Install operation reports that DevCon has created the device node and that it has updated the drivers for the device.
If any step of the DevCon Install operation fails, DevCon displays a failure message and does not proceed with the driver installation.
The DevCon Install command creates a new non-Plug and Play device node each time you run it. To update or reinstall drivers, use the DevCon Update command.
Sample usage
devcon install c:\windows\inf\newdvc.inf ISAPNP\CSC4324\0
devcon /r install c:\windows\inf\newdvc.inf ISAPNP\CSC4324\0