次の方法で共有


Find potential problems using code map analyzers

Note

This article applies to Visual Studio 2015. If you're looking for the latest Visual Studio documentation, see Visual Studio documentation. We recommend upgrading to the latest version of Visual Studio. Download it here

Run analyzers on code maps to help you identify code that might be overly complex or that might need improvement. For example, you can use these analyzers:

To find code that has Examine these areas to see whether
Loops or circular dependencies You can simplify them and consider whether you can break these cycles.
Too many dependencies They are performing too many functions or to determine the impact of changing these areas. A well-formed code map will show a minimal number of dependencies. To make code easier to maintain, change, test, and reuse, consider whether you can refactor these areas so that they are more clearly defined, or whether you can merge code that performs similar functions.
No dependencies They are necessary or whether you should remove this code.

Analyze code maps

  1. On the map toolbar, choose Layout, Analyzers, and then analyzer that you want to run:

    Analyzer To identify nodes that
    Circular References Analyzer Have circular dependencies on each other. Note: Circular dependencies that are in the Generics group are not shown on the map when you expand the group.
    Find Hubs Analyzer Are in the top 25% of highly-connected nodes

    To hide all other nodes on the map

    - Open the shortcut menu for the map, choose Advanced, Select, Hide Unselected.
    The map hides the unselected nodes, and the analyzer identifies new nodes as hubs.
    Unreferenced Nodes Analyzer Do not have references from any other nodes. Caution: Verify each of these cases before assuming that the code is not used. Certain dependencies such as XAML dependencies and run-time dependencies cannot be found statically in the code.

    Code map analyzers will continue to run after you apply them. If you change the map, any applied analyzers will automatically reprocess the updated map. To stop running an analyzer, on the map toolbar, choose Layout, Analyzers. Turn off the selected analyzer.

Tip

If you have a very large map, running an analyzer might cause an out of memory exception. If this occurs, edit the map to reduce its scope or generate a smaller one, and then run the analyzer.

See Also

Map dependencies across your solutions Use code maps to debug your applications Map methods on the call stack while debugging