Using the command prompt for Groove Server Relay
Applies to: Groove Server 2010
Topic Last Modified: 2010-02-16
This article describes how to use the Windows command prompt for Groove Server Relay.
This procedure requires that the following conditions are met:
Groove Server Relay is installed as described in Install and configure Groove Server 2010 Relay.
You are running the Relay server with Administrator permissions.
To use Relay command line entries
From your Groove Server Relay computer, open a Windows command prompt from the Start menu.
If you are not already running the Relay server as Administrator, type run as administrator, and then press Enter.
To access information about Relay server command line entries, open a Windows command prompt, navigate to the Relay server installation directory, and then type: relay –h, and then press the Enter key.
To find version information for the Groove Server Relay executable, open the Relay server installation directory, type relay –v, and then press the Enter key.