Bewerken

Delen via


Methods of Controlling Breakpoints

You can specify the location of a breakpoint by virtual address, module and routine offsets, or source file and line number (when in source mode). If you put a breakpoint on a routine without an offset, the breakpoint is activated when that routine is entered.

There are several additional kinds of breakpoints:

  • A breakpoint can be associated with a certain thread.

  • A breakpoint can enable a fixed number of passes through an address before it is triggered.

  • A breakpoint can automatically issue certain commands when it is triggered.

  • A breakpoint can be set on non-executable memory and watch for that location to be read or written to.

If you are debugging more than one process in user mode, the collection of breakpoints depends on the current process. To view or change a process' breakpoints, you must select the process as the current process. For more information about the current process, see Controlling Processes and Threads.

Debugger Commands for Controlling and Displaying Breakpoints

To control or display breakpoints, you can use the following methods:

In WinDbg, there are several user interface elements that facilitate controlling and displaying breakpoints. See Setting Breakpoints in WinDbg (Classic).

Each breakpoint has a decimal number called the breakpoint ID associated with it. This number identifies the breakpoint in various commands.

Breakpoint Commands

You can include a command in a breakpoint that is automatically executed when the breakpoint is hit. For example, the following command breaks at MyFunction+0x47, writes a dump file, and then resumes execution.

0:000> bu MyFunction+0x47 ".dump c:\mydump.dmp; g" 

Note  If you are controlling the user-mode debugger from the kernel debugger, do not use g (Go) in the breakpoint command string. The serial interface might be unable to keep up with this command, and you will be unable to break back into CDB. For more information about this situation, see Controlling the User-Mode Debugger from the Kernel Debugger.

Number of Breakpoints

In kernel mode, you can use a maximum of 32 software breakpoints. In user mode, you can use any number of software breakpoints.

The number of processor breakpoints that are supported depends on the target processor architecture.

Conditional Breakpoints

You can set a breakpoint that is triggered only under certain conditions. For more information about these kinds of breakpoints, see Setting a Conditional Breakpoint.

Ambiguous Breakpoints

In version 10.0.25310.1001 and later of the debugger engine, ambiguous breakpoint resolution is now supported. Ambiguous breakpoints allow for the debugger to set breakpoints in certain scenarios where a breakpoint expression resolves to multiple locations. For more information, see Ambiguous breakpoint resolution.

See also

Using Breakpoints

Breakpoint Syntax

bp, bu, bm (Set Breakpoint)

Unresolved Breakpoints (bu Breakpoints)