Rediger

Del via


HMAC.Key Property

Definition

Gets or sets the key to use in the HMAC calculation.

public:
 virtual property cli::array <System::Byte> ^ Key { cli::array <System::Byte> ^ get(); void set(cli::array <System::Byte> ^ value); };
public override byte[] Key { get; set; }
member this.Key : byte[] with get, set
Public Overrides Property Key As Byte()

Property Value

Byte[]

The key to use in the HMAC calculation.

Exceptions

An attempt is made to change the Key property after hashing has begun.

Remarks

This property is the key for the keyed hash algorithm.

A Hash-based Message Authentication Code (HMAC) can be used to determine whether a message sent over an insecure channel has been tampered with, provided that the sender and receiver share a secret key. The sender computes the hash value for the original data and sends both the original data and the HMAC as a single message. The receiver recomputes the hash value on the received message and checks that the computed hash value matches the transmitted hash value.

HMAC can be used with any iterative cryptographic hash function, such as MD5 or SHA-1, in combination with a secret shared key. The cryptographic strength of HMAC depends on the properties of the underlying hash function.

Any change to the data or the hash value results in a mismatch, because knowledge of the secret key is required to change the message and reproduce the correct hash value. Therefore, if the original and computed hash values match, the message is authenticated.

Due to collision problems with MD5 and SHA-1, Microsoft recommends a security model based on SHA-256 or better.

Applies to

See also