ערוך

שתף באמצעות


Microsoft Defender for Identity standalone sensor prerequisites

This article lists prerequisites for deploying a Microsoft Defender for Identity standalone sensor where they differ from the main deployment prerequisites.

For more information, see Plan capacity for Microsoft Defender for Identity deployment.

Important

Defender for Identity standalone sensors do not support the collection of Event Tracing for Windows (ETW) log entries that provide the data for multiple detections. For full coverage of your environment, we recommend deploying the Defender for Identity sensor.

Extra system requirements for standalone sensors

Standalone sensors differ from Defender for Identity sensor prerequisites as follows:

  • Standalone sensors require a minimum of 5 GB of disk space

  • Standalone sensors can also be installed on servers that are in a workgroup.

  • Standalone sensors can support monitoring multiple domain controllers, depending on the amount of network traffic to and from the domain controllers.

  • If you're working with multiple forests, your standalone sensor machines must be allowed to communicate with all remote forest domain controllers using LDAP.

For information on using virtual machines with the Defender for Identity standalone sensor, see Configure port mirroring.

Network adapters for standalone sensors

Standalone sensors require at least one of each of the following network adapters:

  • Management adapters - used for communications on your corporate network. The sensor uses this adapter to query the DC it's protecting and performing resolution to machine accounts.

    Configure management adapters with static IP addresses, including a default gateway, and preferred and alternate DNS servers.

    The DNS suffix for this connection should be the DNS name of the domain for each domain being monitored.

    Note

    If the Defender for Identity standalone sensor is a member of the domain, this may be configured automatically.

  • Capture adapter - used to capture traffic to and from the domain controllers.

    Important

    • Configure port mirroring for the capture adapter as the destination of the domain controller network traffic. Typically, you need to work with the networking or virtualization team to configure port mirroring.
    • Configure a static non-routable IP address (with /32 mask) for your environment with no default sensor gateway and no DNS server addresses. For example: `10.10.0.10/32. This configuration ensures that the capture network adapter can capture the maximum amount of traffic and that the management network adapter is used to send and receive the required network traffic.

Note

If you run Wireshark on Defender for Identity standalone sensor, restart the Defender for Identity sensor service after you've stopped the Wireshark capture. If you don't restart the sensor service, the sensor stops capturing traffic.

If you attempt to install the Defender for Identity sensor on a machine configured with a NIC Teaming adapter, you receive an installation error. If you want to install the Defender for Identity sensor on a machine configured with NIC teaming, see Defender for Identity sensor NIC teaming issue.

Ports for standalone sensors

The following table lists the extra ports that the Defender for Identity standalone sensor requires configured on the management adapter, in addition to ports listed for the Defender for Identity sensor.

Protocol Transport Port From To
Internal ports
LDAP TCP and UDP 389 Defender for Identity sensor Domain controllers
Secure LDAP (LDAPS) TCP 636 Defender for Identity sensor Domain controllers
LDAP to Global Catalog TCP 3268 Defender for Identity sensor Domain controllers
LDAPS to Global Catalog TCP 3269 Defender for Identity sensor Domain controllers
Kerberos TCP and UDP 88 Defender for Identity sensor Domain controllers
Windows Time UDP 123 Defender for Identity sensor Domain controllers
Syslog (optional) TCP/UDP 514, depending on configuration SIEM Server Defender for Identity sensor

Windows event log requirements

Defender for Identity detection relies on specific Windows Event logs that the sensor parses from your domain controllers. For the correct events to be audited and included in the Windows Event log, your domain controllers require accurate Windows Advanced Audit Policy settings.

For more information, see, Advanced audit policy check and Advanced security audit policies in the Windows documentation.

Next steps