_mm256_nmsub_pd

Artigo
07/22/2011

[Note: This document describes a pre-release version of Visual Studio 2010 SP1 and may be revised in any later version.]

Visual Studio 2010 SP1 is required.

Microsoft Specific

Generates the FMA4 YMM instruction vfnmsubpd to perform a single-round double-precision negative multiply-subtract of its sources.

__m256 _mm256_nmsub_pd (
   __m256 src1,
   __m256 src2,
   __m256 src3
);

Parameters

[in] src1
A 256-bit parameter that contains eight 32-bit floating-point values.
[in] src2
A 256-bit parameter that contains eight 32-bit floating-point values.
[in] src3
A 256-bit parameter that contains eight 32-bit floating-point values.

Return value

A 256-bit result r that contains eight 32-bit floating-point values.

r[i] := -(src1[i] * src2[i]) - src3[i];

Requirements

Intrinsic	Architecture
_mm256_nmsub_pd	FMA4

Header file <intrin.h>

Remarks

Each of the four double-precision floating-point values in src1 is multiplied by the corresponding value in src2. The result is negated, the corresponding value in src3 is subtracted from it, and the result is stored as the corresponding value in the destination. Each multiply-negate-subtract is performed with a single round at the end, as if intermediate results were computed to infinite precision.

The vfnmsubpd instruction is part of the FMA4 family of instructions. Before you use this intrinsic, you must ensure that the processor supports this instruction. To determine hardware support for this instruction, call the __cpuid intrinsic with InfoType = 0x80000001 and check bit 16 of CPUInfo[2] (ECX). This bit is 1 when the instruction is supported, and 0 otherwise.

Example

#include <stdio.h>
#include <intrin.h>
int main()
{
    __m256d a, b, c, d;
    int i;
    for (i = 0; i < 4; i++) {
        a.m256d_f64[i] = i;
        b.m256d_f64[i] = 2.;
        c.m256d_f64[i] = 3.;
    }
    d = _mm256_nmsub_pd(a, b, c);
    for (i = 0; i < 4; i++) printf_s(" %.3lf", d.m256d_f64[i]);
    printf_s("\n");
}

-3.000 -5.000 -7.000 -9.000

Change History

Date	History	Reason
March 2011	Added this content.	SP1 feature change.

March 2011

Added this content.

SP1 feature change.

Compartilhar via